Installation Sheet

12. Hold hangers to door, aligning edge A with top of
door and edge B with marked line.
Clamp in place and mark centre of Hole 1 and Slot 2
onto face of door for drilling reference.
Fasten hangers to door
13
. Pre-drill through door using ø8mm (15/16”) drill bit.
Ensure holes are perpendicular to front face of door.
Drill out with ø12mm (15/32”) drill.
If you are installing SofStop, follow steps 20-21,
Page 4 to fit the activator to the top of the door.
If you are installing SofStop, turn to Page 4
14
. Check alignment of hanger and fasten to door with
door bolts supplied. Do not over-tighten.
A
1
2
B
Door
Hanger
Marked
line
Mark
centre of
holes
Door
Align edge
with top of
door
Align edge
with top of
door
Door
bolt
3
Lift door onto track
16
. Lift the door onto the track.
Adjust track offset
15
. Before lifting the door on the track, check the
clearance. Loosen all bolts one turn and adjust the
track so that the door will be at desired offset from
wall. Re-tighten bolts.
Position stops
19
. Move door to open position.
Position rubber part of stop against hanger as shown.
Tighten cap screws to lock stop in place.
Close the door and repeat for the other stop.
Check T-Guide position
17
. Ensure the T-Guide
is between point C
and O marked on the
floor and the desired
distance away from
the wall.
Stop
Hanger
c
L
c
L
OC
12
13 14
15
17
19
16
18
18. Roll door back far
enough to mount
T-Guide. If this means
rolling off the end of
the track, ensure door
weight is supported
using a block.
PAGE
Adjustable
Loosen bolts
to adjust