User manual
CBC (America) www.computarganz.com
52
USER MANUAL
•
sensorwidth
- width of sensor window (valid values defined by sensor size;
this value affects sensor frame rate)
•
sensorheight
- height of sensor window (valid values defined by sensor size;
this value affects sensor frame rate)
•
imgleft
- left coordinate of default image returned in response to the
simple request http://ip_address/img.jpg (valid values should fall within
sensor window)
•
imgtop
- top coordinate of default image returned in response to the
simple request http://ip_address/img.jpg (valid values should fall within
sensor window)
•
imgwidth
‒ width of default image returned in response to the simple
request http://ip_address/img.jpg (valid values should fall within sensor
window)
•
imgheight
- height of default image returned in response to the simple
request http://ip_address/img.jpg (valid values should fall within sensor
window)
•
imgquality
‒ quality setting of image returned in response to the simple
request http://ip_address/img.jpg (valid values 1 to 21)
•
imgres
‒ resolution of default image returned in response to the simple
request http://ip_address/img.jpg (valid values are full and half, where half
is used to request images decimated by a factor of 2 in both directions)
•
auto
-
iris
‒ allows to enable and disable auto-iris (valid values are on and off)
•
irisgain
‒ allows to specify threshold for closing the auto-iris (valid values
are from 8 to 255)
•
save
‒ saves current camera configuration (all parameter values) in the
non-volatile memory http://ip_address/set?params=save
•
mac
‒ retrieves the MAC address of the camera (read-only)
•
model
‒ retrieves last 4 numbers of the camera model (read-only, e.g.
MP2100 camera will return 2100)
•
fwversion
‒ retrieves firmware version of the camera
•
procversion
‒ retrieves version of the image processor
•
netversion
‒ retrieves version of the network processor
•
revision
‒ retrieves the revision code of the PCB
•
factory
‒ restores camera parameters to factory defaults
http://ip_address/set?params=factory
• access to camera registers:
setreg?page=page_number®=register_number&val=register_value