User manual

Speed Dome Camera Instruction Manual

20/74

 Alarm Input

z Sensor Input

Before connecting sensors, check driving voltages and output signal types of the sensors.

Since output signal types of the sensors are divided into Open Collector type and

Voltage Output type in general, the wiring must be done properly after considering

those types.

Signal

Description

IN COM+

The electric power source to drive input circuit. Connect the (+) wire of electric

power source to drive the Sensors to this port as shown in the above circuit.

IN1 -, IN2 -, IN3 -

Connect the outputs of sensors to each port as shown in the above

circuit.

If you want to use Alarm Input, the types of sensors must be selected in OSD menu. The

sensor types are divided into Normal Open and Normal Close. If wrong sensor types are

selected, alarms should be activated reversely to sensor inputs.

~ Normal Open

Output Voltage is high state when sensor is activated

~ Normal Close

Output Voltage is high state when sensor is not activated

INSTALLATION