User manual

G
G
Speed Dome Camera Instruction Manual
25/74
Preset
z Function
MAX. 127 positions are programmable. The Preset number can be
assigned from 1 to 128 except 95. Preset 95 is reserved for enter
ing
into OSD menu. Camera parameters such as
White Balance, Auto
Exposure and others can be set up independently and
each preset
can have its own
parameter values independently from the other
persets. When setting up presets with a controller,
Label should be
blank and "Camera Adjust" should be set to "GLOBAL" as the
default.
To change the parameters, enter into OSD menu.
z Setting Presets
Set Preset [1~128]
z Running Presets
Go Preset [1~128]
z Deleting Presets
To delete Presets, enter into OSD menu.
Swing
z Function
This function is that the camera moves repetitively between two
preset positions at programmed speeds. When a
swing function runs,
the camera moves from the preset assigned as
the 1st point to the
preset assigned as the 2nd point in CW(Clockwise) direction. Then
the
camera moves from the preset assigned as the 2nd point to the
preset assigned as the 1st point in CCW(Counterclockwise)
direction.
In case that the preset assigned as the 1st point and
the preset
assigned as the 2nd point are same, the camera
turns on its axis by
360q in CW(Clockwise) direction and then it turns back
on its axis by
360q in CCW(Counterclockwise) direction.
The Swing speed is
defined from 1
q
/sec to 180
q
/sec.
z Setting Swings
To set Swing, enter into OSD menu.
z Running Swings
Method 1) <Run Pattern> [Swing NO. + 10]
Method 2) <Go Preset> [Swing NO. + 140]
ex) Run Swing 3 : <Run Pattern> [13]
ex) Run Swing 3 : <Go Preset> [143]
z Deleting Swings
To delete Swings, enter into OSD menu.
OPERATION
3