Installation guide

Installation Guide

Follow the steps below to mount the PTZ Camera with the Corner Mounting Plate

and Standard/Mini Pendent Mount.

1) Make a cable entry hole on the wall to recess the cable(s).

2) Fix the Corner Mounting Plate on the corner of the wall with proper screws and

screw anchors. Then run the cable(s) through the hole on the Corner Mounting

Plate with the Data Cable’s 22-pin cable coming out.

3) Fasten the Standard/Mini Pendent Mount onto the Corner Mounting Plate with

the supplied screws and washers. Then thread the cable(s) through the

Standard/Mini Pendent Mount with the cable(s) coming out of the Pendent

Mount’s outlet.

NOTE: Please block the cable entry hole with the supplied sponge to

avoid insects entering the Pendent Mount. See the illustrations in section

4.4.1 Compact Pendent Mount

> Step 4.

4) Attach the Waterproof Rubber to the Standard/Mini Pendent Mount.

5) Thread the cable(s) through the Indoor Mount Kit and join the Indoor Mount Kit to

the Standard/Mini Pendent Mount with the supplied screws and washers. Then

adjust the Waterproof Rubber to the joint.

6) Connect the cable(s) to the PTZ Camera.

7) Join the PTZ Camera to the Indoor Mount Kit with the supplied screw and

washers.

Corner Wall Mounting: Corner Standard/Mini Mounting Plate + Standard/Mini

Pendent Mount + Indoor Mount Kit