Installation guide

Installation Guide

Follow the steps below to mount the PTZ Camera with the Pole Thin/Wide Direct

Mounting and Standard/Mini Pendent Mount.

1) Fasten the Pole Thin/Wide Direct Mounting on a pole with equipped stainless

straps.

2) Run the cable(s) through the hole on the Pole Thin/Wide Direct Mounting with the

Data Cable’s 22-pin cable coming out.

3) Fasten the Standard/Mini Pendent Mount onto the Pole Thin/Wide Direct

Mounting with the supplied screws and washers. Then thread the cable(s)

through the Standard/Mini Pendent Mount with the cable(s) coming out of the

Pendent Mount’s outlet.

NOTE: Please block the cable entry hole with the supplied sponge to

avoid insects entering the Pendent Mount. See the illustrations in section

4.4.1 Compact Pendent Mount

> Step 4.

4) Attach the Waterproof Rubber to the Standard/Mini Pendent Mount.

5) Thread the cable(s) through the Indoor Mount Kit and join the Indoor Mount Kit to

the Standard/Mini Pendent Mount with the supplied screws and washers. Then

adjust the Waterproof Rubber to the joint.

6) Connect the cable(s) to the PTZ Camera.

7) Join the PTZ Camera to the Indoor Mount Kit with the supplied screw and

washers.

Pole Direct Mounting: Pole Thin/Wide Direct Mounting + Standard/Mini Pendent

Mount + Indoor Mount Kit