User Manual

Bluetooth USB Dongle BTW Configuration & User’s Guide
33
8 Troubleshooting
8.1 CANNOT CONNECT TO A PAIRED DEVICE:
Paired devices are always displayed in My Bluetooth Places, even if the remote device is
out of range or not powered up.
Verify that the remote member of the pair is within radio range and powered up and then
attempt the connection again.
8.2 C
ANNOT DISCOVER SERVICES ON AN UN
-
PAIRED REMOTE DEVICE
:
The remote device may not be powered up or may be out of range.
•
Verify that the remote device is powered up.
•
Verify that the remote device is in Connectable mode (Bluetooth Configuration
Panel > Accessibility tab).
•
Perform a Search for Devices to verify that the device is within range.
8.3 D
IAL
-
UP
N
ETWORKING SERVICE DOES NOT START
:
The Dial-up Networking service will not start unless a properly configured modem is
attached to the server.
•
Verify that the modem is usable as a local device from the server.
• In the Bluetooth Configuration Panel, Local Services tab, double-click the Dial-up
Networking service:
 Click the down arrow in the Modem field and select the modem that will be
used to dial out
 Click the OK button
 Click the OK button to close the Bluetooth Configuration Panel.
8.4 H
OW DO
I
DETERMINE THE
B
LUETOOTH
D
EVICE
A
DDRESS
(BDA)
OF MY
HARDWARE DEVICE
?
In the Bluetooth Configuration Panel, on the Hardware tab, in the Devices section, select
the device you want to determine the address of. In the Device Properties section of the
dialog box, the fourth entry, Device Address, is the BDA of the selected Bluetooth device.
8.5 H
OW DO
I
DETERMINE THE VERSION NUMBER OF THE
B
LUETOOTH
S
PECIFICATION
THAT THE
H
OST
C
ONTROLLER
I
NTERFACE
(HCI)
COMPLIES WITH
?
In the Bluetooth Configuration Panel, on the Hardware tab, in the Device Properties
section, the fifth entry provides Bluetooth Specification compliance information for the
Host Controller Interface.
The sixth entry contains the Specification Revision information for the Host Controller
Interface, if appropriate.
8.6 H
OW DO
I
DETERMINE THE VERSION NUMBER OF THE
L
INK
M
ANAGER
P
ROTOCOL
(LMP)?
In the Bluetooth Configuration Panel, on the Hardware tab, in the Device Properties
section, the seventh entry provides Link Manager Protocol version number information.
The eighth entry contains the Link Manager Protocol sub-version number information, if
appropriate.