User's Manual

USER’S MANUAL OF WLAN ACCESS POINT Version: 2.1
4
2 Installation
2.1 Hardware Installation
Step One: Place the Wireless LAN Access Point to the best optimum transmission
location.
The best transmission location for your WLAN Access Point is usually at the
geographic center of your wireless network, with line of sign to all of your mobile
stations.
Step Two: Connect the Wireless LAN Access Point to your wired network.
Connect the Wireless LAN Access Point by category 5 Ethernet cable to your
switch/ hub/ router/ xDSL modem or cable modem. A straight-through Ethernet
cable with appropriate cable length is needed.
Step Three: Supply DC power to the Wireless LAN Access Point.
Use only the AC/DC power adapter supplied with the Wireless Access Point; it may
occur damage by using a different type of power adapter.
The hardware installation finished.
2.2 Software Installation
 There are no software drivers, patches or utilities installation needed, but only the
configuration setting. Please refer to chapter 3 for software configuration.