User Guide

Page 1 (cover) Page 2 (inside)
Page 3 (inside) Page 4 (back)
Black border shows
page size and should
not print
Black border shows
page size and should
not print
11.0"
8.50"
Features:
•Realistic LED 3-D Flame Effect
•Three Settings:
High (1200 watts - 4095 BTUs)
Low (600 watts)
3-D Flame Only
•Fan Forced Air Circulation
•No Venting Required
•Stay Cool Composite Body
•Safety Tip-Over Cutoff Switch
•Safety Overheat Protection
•120V A.C. / 60Hz. 10.0 Amps
Save These Instructions
Ceramic Fireplace Heater
Model #CZFP1
USAGE:
HEATER OPERATION: Always operate the heater in
the
upright position following all instructions and
recommendations
listed in this manual HEATER
LOCATION: Place the heater
in the area of the room that
is coldest. HEATER CONNECTION:
Plug heater directly
into 120 volt A.C., 60 Hz wall outlet. Be
sure plug fits
tightly in outlet. A loose connection may cause
overheating and damage to the plug or heater. NOTE:
To prevent overloading a circuit, do not plug the
heater into a circuit that is servicing other electrical
needs.
TURNING HEATER ON:
For LED Flame Effect Only - Rotate Power On/Off
Flame Control switch to FLAME Setting. Indicator light
will come on.
For Low Heat (600 watts) - Rotate Power On/Off Flame
Control switch to LOW position.
For High Heat (1200 watts) - Rotate Power On/Off
Flame Control to HIGH position.
ROTARY POWER ON/OFF FLAME CONTROL: This
heater has two heat settings: HIGH and LOW. Use the
higher setting (1200 watt) to raise the room
temperature quickly. When the desired temperature is
reached use the LOW (600 watt) setting. It is usually
sufficient to maintain a comfortable temperature.
POWER INDICATOR: The Power Indicator Light
located on the switch will illuminate when the Power
On/Off Flame Control switch is turned on any setting.
TO OPERATE SIMULATED FLAME ONLY: Rotate the
Power On/Off Flame Control switch to FLAME to have
the flame effect without any heater functions.
TURNING OFF: Turn the Power On/Off Flame Control
to OFF to discontinue use. Heater should be
unplugged when not in use.
IMPORTANT SAFETY FEATURES
The power indicator light, located near the Power
On/Off Flame Control switch, lights whenever the
heater is turned on any setting to tell you that the
heater is functioning properly.
The heater is equipped
with an automatic overheat protection device located
inside the body of the heater. If the heater grill is
obstructed, or if the heater gets too hot for any
reason, the automatic overheat protection device will
turn the heater off. To reset the heater, simply turn
power off and unplug the heater for 20 minutes until it
cools down and you may plug the heater in and
restart the heater. Be sure that the heater is on a
smooth level surface with no obstructions. The heater
is also equipped with a safety tip-over switch to turn
power off to the heater when the heater tips over. To
resume heater functions simply stand heater upright.
Be sure that the heater is on a smooth level surface
where the heater will not be accidently tipped over.
CARE AND MAINTENANCE
CLEANING: CAUTION-Before cleaning the heater be
sure
to disconnect power cord and allow the heater to
cool
completely. Clean the outside surface with a
clean damp cloth. Do not use harsh chemical or
abrasive cleaners. DO NOT IMMERSE THE HEATER
IN WATER. Allow heater to dry completely before use.
Use a vacuum or duster to keep heat and vent area
clean and free of dust and dirt.
REPAIR: DO NOT OPERATE THE HEATER WITHOUT
THE GRILL IN PLACE. DO NOT USE THE HEATER IF
IT HAS MALFUNCTIONED OR BECOME DAMAGED
IN ANY WAY.
STORAGE: Keep original carton for storage of the
heater. Coil and tie the power cord to avoid damage
during storage.
LIMITED WARRANTY
Products manufactured by Comfort Zone® are warranted to the original consumer to be free of
defects in material and workmanship for twelve (12) months from the original date of purchase. The
warranty does not cover products modified outside our factory, damage or failure caused by acts of
God, abuse, misuse, abnormal usage, faulty installation, failure to follow suggested maintenance
procedures enclosed with this product (as defined by Magnuson-Moss Warranty-Federal Trade
Commission lmprovement Act) This unit is guaranteed to the original retail purchaser against defects
in quality or workmanship for a period of one year from the date of original purchase. If this unit fails
because of a manufacturing defect within 30 days of purchase, return the unit, with your receipt, to the
retailer. After 30 days, but within the warranty period, if the unit was purchased within the continental
united States, return it, freight prepaid, to Comfort Zone® for repair or replacement. If the unit was
purchased outside the continental united States, return the unit to the place of purchase. This
warranty does not cover damage due to accidents, operation on other than 120 volts, 60 hertz, AC.
current, or any other abuse. All implied warranties, including the warranties of merchantability and of
fitness of purpose, if applicable, are hereby limited in duration to the period of one year from the date
of original retail purchase. Some states do not allow limitations on how long an implied warranty lasts,
so the above limitations may not apply to you. Incidental or consequential damages arising from a
breach of either express or implied warranties are hereby disclaimed and excluded. Some states do
not allow the exclusion of limitation of incidental or consequential damages, so this limitation or
exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from state
to state. No informal dispute settlement mechanisms are available. This limited warranty is given in
lieu of all other warranties.
Manufactured by:
Comfort Zone®
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneheaters.net
SAVE THESE INSTRUCTIONS
INTENDED USE:
This product is intended for indoor residential and office
use only, not for industrial or other commercial
applications. Use only with electrical wiring that is in
good working order and that meets applicable codes
and ordinances. If you have any questions whether
your wiring is adequate, consult a qualified electrician.
Use your heater only with a working smoke detector
located in the vicinity of your heater.
While using your heater, you should follow the
IMPORTANT INSTRUCTIONS listed below. As part of
those instructions, we have used the word
'
WARNING” to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided,
could result in injury or death.
IMPORTANT INSTRUCTIONS
As with all electrical appliances, basic safety
precautions
should always be followed to reduce the risk
of electric shock,
fire, or injury to persons, including the
following precautions:
•Read all the instructions before using this
heater.
•Use this heater only as described in this
manual. Any other use not recommended by the
manufacturer may cause electrical shock, fire or
damage to persons or property.
•Do not operate the heater with a damaged
power cord or after the heater malfunctions or has
been dropped in any manner.
•Do not use with cracked or broken glass.
•Do not use heater unattended. Use of extreme
caution is necessary when any heater is used by or
near children, disabled persons or pets.
•Do not place the heater on a small, unlevel,
uneven or any surface which might allow heater to tip
or fall.
•For proper operation, heater should be placed
on a smooth, non-combustible surface. Do not place
on rugs or carpet.
•Always unplug heater when not in use.
•Do not operate the heater with heater guards
or any safety device removed.
•Always plug heaters directly into a wall
outlet/receptacle. Never use with an extension cord
or relocatable power tap (outlet/power strip).
•Do not run power cord under carpeting. Do not
cover
cord with throw rugs, runners or the like.
Arrange cord away
from traffic area where it will not
be tripped over.
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is
not intended for use in a bathroom, laundry area, or
similar
locations, or near sinks, washing machines,
swimming pools
or other sources of water. Never locate
heater where it may fall into a bathtub or other water
container. Do not use heater outdoors. Do not use in
damp environments such as flooded basements.
®
Carry
Handle
Power
On/Off
Flame
Control
Power
Indicator
WARNING: HOT SURFACES
Do not touch body of heater when in use. This heater is
hot when in use, to avoid burns, do not let bare skin
touch hot surfaces. If provided, use handles when
moving this heater.
WARNING: FIRE HAZARD
Heater has hot and arcing or sparking parts inside. Do
not use near combustible materials or flammable gases
or sources of heat. DO NOT USE in areas where gasoline,
paint or flammable materials are used or stored. This
heater is hot when in use. If provided, use handles when
moving this heater. To avoid burns, do not let bare skin
touch hot surfaces. Keep
combustible materials such as
furniture, pillows, bedding, papers, clothes and curtains
at least 3 feet (0.9 m) from the
front of the heater and
keep them away from the sides and rear. To prevent a
possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces, like a bed, where
openings may become blocked. Do not place the
heater near a bed because objects such as pillows or
blankets can fall off the bed and be ignited by the
heater. Do not insert or allow
foreign objects to enter any
ventilation or exhaust opening
as this may cause an
electric shock, fire, or damage the heater
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with
adequate electrical system that is up to code.
The supply cord has a polarized plug. As a safety
feature this plug will fit in a polarized outlet only one
way. To prevent electric shock, match wide blade of
plug to wide slot, fully insert plug. If the plug does not fit
contact a qualified electrician. Never use an extension
cord. DO NOT attempt to defeat this safety feature.
Do not operate any heater with a damaged cord or plug
or after heater malfunctions, has been dropped or
damaged in any manner. Do not operate heater with a
broken heating element or ceramic cone or any visual
imperfections. For repairs covered under warranty, see
warranty statement. For all other repairs contact Comfort
Zone's Customer Service by telephone or mail for
information and assistance.
DO NOT run power cord under carpeting. DO NOT cover
cord with throw rugs, runners or the like. Arrange cord
away from traffic area where it will not be tripped over.
Always plug heater directly into a wall outlet/receptacle.
Never use with an extension cord or relocatable power
tap (outlet/power strip).
Unplug the heater when not in
use. Do not operate heater with its ventilation
obstructed.
CONFIRM