User's Manual

ManualsBrandsCCI ManualsPaintballCCI Phantom

User’s Manual

Paintball Gun

Component Concepts, Inc., 530 South Springbrook Road, Newberg, OR 97132

Phone: (503) 554-8095 Fax: (503) 554-9370

Component Concepts, Inc.

The Phantom™ Paintball

Gun User’s Manual

The information in this manual is subject to change without

notice and does not represent a commitment on the part of

Component Concepts, Inc. CCI reserves the right to make

improvements to products without incurring any obligation to

incorporate such improvements in products previously sold.

This manual contains information protected by copyright.

No part of this manual may be photocopied or reproduced in

any form without prior written consent from Component

Concepts, Inc.

All rights are reserved.

The PHANTOM™ is a registered trademark of

Component Concepts, Inc.

The Phantom™ User’s Manual i

Summary of content (11 pages)

PAGE 1
Paintball Gun User’s Manual Component Concepts, Inc. The Phantom™ Paintball Gun User’s Manual The information in this manual is subject to change without notice and does not represent a commitment on the part of Component Concepts, Inc. CCI reserves the right to make improvements to products without incurring any obligation to incorporate such improvements in products previously sold. This manual contains information protected by copyright.
PAGE 2
Precautions Safety-Your Responsibility...................................... 1 Description and Operation Introduction ............................................................. Specifications.......................................................... The Gun Safety....................................................... CO2 Installation ....................................................... Puncture Adapter Removal………………………….. Load and Fire Paintballs .........................................
PAGE 3
2 The Phantom™ User’s Manual
PAGE 4
Description and Operation CO2 Installation Stock Place 12 gram CO2 cartridge in stock housing. Screw stock housing with cartridge onto puncture adapter. This action pierces cartridge and pressurizes gun.
PAGE 5
Description and Operation Velocity adjustment Temperature and altitude influences the performance of CO2.
PAGE 6
Service and Maintenance Cup Seal and O-ring Replacement An extra O-ring and cup seal has been supplied to help you 8 The Phantom™ User’s Manual
PAGE 7
Service and Maintenance Service and Maintenance Service Notes Service Notes If your fitting should leak the internal O-ring in the fitting needs to be replaced. De gas the marker. Remove the tube by pushing in the collet and pulling the tube out. If you have a metal type tube you also need to remove the rear thumb screw. Pull and wiggle the collet back and forth to extract from fitting body. Replace the O-ring.
PAGE 8
Item # 15 16 17 18 19 20 21 12 Part# 9115 9103 9116 9062 9051 9052 9045 Description Retainer Power Tube, Modified Short Power Tube Assembly, Modified Anti-Kink Hammer Assembly Main Spring Tuned Port Compensator Bolt (21A, 14) The Phantom™ User’s Manual
PAGE 9
Service and Maintenance Accessories 14 The Phantom™ User’s Manual
PAGE 10
Warranty and Disclaimers Disclaimers This limited warranty does not extend to any products not purchased from Component Concepts, Inc.
PAGE 11
______________________ ______________________ ______________________ Component Concepts, Inc.