User's Manual

6. Carefully dump out the Spring and Regulator Spring Seat (this may take a
few taps on your hand or a non-marring surface).
7. Unscrew the 3/16 adjustment screw from the bottom.
8. Clean the bottom portion and replace the Regulator piston or Regulator
Piston O-Ring if necessary.
9. CCM packs the lower portion in clear grease. Apply a coat of Dow® 55 or
Hater Sauce on the Piston and Piston O-Ring during reassembly.
10. Put the regulator bottom back together and screw in the 3/16th screw flush
with the base of the reg.
11. Reassemble the regulator in the reverse order of the steps above and
check it for leaks. A simple pressure testing kit could be employed to set
your regulator at a desired pressure before attaching it to the marker.