ale-CORVETTE € ® Radio Shack. Supercharged Racer i CANER'S MANUAL — w Please read before using this equipment, . 60-4343 Li TURN SIGNAL R and TURN SIGNAL L —See page # 4 ON/OFF | HAZARD See page # 4 &— Thank you for purchasing the Radio Shack Built ta */42 scale, it can reach speeds up to 450 feet per minute. The digital proportional speed and steering controls on the pistol grip transmitter provides excellent control for the racer.
[— FAA Dispose of batteries promptly and properly, Do not bury or burn batteries, —% @ INSTALLING BATTERIES IN THE TRANSMITTER You need ane SV battery to power the transmitter, For the best performance and longest life, we recommend a Radio Shack alkaline battery. L. Unfold the transmitter so the grip snaps anti place. 2. Slide the battery compartment cover to remove it, 3. Place the battery in the compartment as indicated by the polarity symbols (+ and -) marked inside. 4. Replace the cover.
| ¢ CHARGING THE VEHICLE 1. After installing the fresh batteries, place the vehicle on the charge stand so its plug fits into the jack an the vehicle, 2. Press the button on the charging stand so the red indicator turns on. The stand starts to charge the vehicle's battery. 3. When the indicator goes off, the charging cycle is complete. Remove the vehicle from the stand Of INSTALLING THE TRANSMITTER ANTENNA Thread the antenna info the transmitter’s antenna connector. Make sure the connection is tight.
0 =e DRIVING THE CAR Fully extend the transmitter's antenna. Slide ON/OFF on the transmitter and the vehicle to ON, You might need a pair of tweezers or a small precision screwdriver to move the vehicle's switch, Use the transmitter's trigger and wheel to drive and steer the car. A @ Steering Control Wheel TURN SIGNAL L ~Press TURN SIGNAL L to turn + Rotate the wheel left to turn left the left indicator on or off.
ADJUSTING THE WHEEL ALIGNMENT If the vehicle does not drive in a straight line when you release the steering wheel, adjust the wheel alignment control on the bottom of that car, Rotate the control toward L if the car is pulling to the right, Rotate the control toward R if the car is pulling to the left. Wheel Alignment Central FOLDING THE TRANSMITTER 1, Press the button of the transmitter grip and fold the transmitter. 2.
toes HELPFUL HINTS $ If someone uses a CB nearby, it might interfere with control of the vehicle. If this happens, move the car away from the CB Be grue the car is not out of the transmitter's range. The range depends on the surroundings and on battery strength. Obstructions such as buildings, fences, and so on, between the transmitter and the vehicle, reduce the range. The vehicle has a special circuit to prolong battery life.
) THE FCC WANTS YOUTH KNOW This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference they may cause undesired operation, Your vehicle or transmitter might cause TV or roadie interference even when it is operating properly.
we Limited Ninety-Day Warranty This product is warranted by Radio Shack against manufacturing defects in material and workman ship under normal use for ninety (80) days from the date of purchase from Radio Shack company owned stores and authorized Radio Shack franchisees and dealers, EXCEPT AS PROVIDED HEREIN, Radio Shack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANT ABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TC THE DURATION OF THE WRITTEN LIM
tem No. 60-4343 Additional Waring in the instruction manual Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
