User's Manual

PAGE 1
Copy dp lab Cerf. Included: 1. Controller 6. Motor with Pinier 2. Charger 7. Antenna n. Tes g Control Trigger + Car Body 3. Motor Clip 5. Chassis 1) Attach tires on each shaft. insert motor into the chassis as shown. 3) Press the motor Clip on the top of the motor. 4) Clo the car body onto chassis. 1) insert $4AAA batteries into the charger following the + markings 1 2 insert 1x Sv battery into the controller following the + / markings 1)Set the onion switch on the car ta OFF, 2 Open the car body.
PAGE 2
Clip the outside of the pack together to make a jumping ramp. Steering Wheel Alignment 1} Use the lever under the chassis to align the steering. 2) ¥ your car is driving te the left, move the lever to the right until corrected. 3) If your car is driving right, move the lever to the left, Tune your car with additional motors, gears, and tires available separately with different body tops and wheel hubs also available separately.