User's Manual

Parts identification
Connecter must be fitted firmly. If The plug must only be fitted facing one
the connecter is not fixed direction. Always ensure that the black cable
correctly, it may come lead wire is facing outwards when the servo
disconnected and cause vehicle and switch harness are connected to
to go out of control. the receiver.
When the connecter is
removed, pull it by the housing
Battery Switch Harness
not by the cable.
CH1 Steering Servo
CH2 Speed Controller or
Set up button
Throttle Servo
Antenna lead
Receiver Connection
Connect the battery and motor with correct polarity.(* Incorrect polarity causes product damage)
The manufacturer and distributor will accept no responsibility, expressed or implied, for problems
caused by usage of Non-genuine parts.
When you have finished driving your car, remove batteries to prevent danger of
activation if accidentally switched on.
RECEIVER
6