Specifications

S: Strobe Light Width Setting Command
Name Strobe Light Width Setting command
Header
code
S
Function It sets the pulse width for strobe light.
@ 99 S 99999 R/W FF CR LF
Command
Header Channel
Strobe
light width
Write flag Checksum
Delimiter
Response
@ 99 O FF CR LF
OK
Command
Header Channel Checksum Delimiter
@ 99 N 9 FF CR LF
NG
Command
Header Channel Error No. Checksum Delimiter
Strobe light width may be set from 20µs to 33,000 µs.
Although it can be set increment of 1µs, it will actually be rounded as shown at
“2-4 Strobe Light”. (Strobe light width can not be set with 1µs increment)
F: Light Pulse Width Setting Command
Name Light Pulse Width Setting Command
Header
code
F
Function It sets the duty ratio for pulsed light width.
@ 99 F 999 R/W FF CR LF
Command
Header Channel
Light pulse
width
Write flag
Check
sum
Delimiter
Response
@ 99 O FF CR LF
OK
command
Header Channel Checksum Delimiter
@ 99 N 9 FF CR LF
NG
command
Header Channel Error No.
Check
sum
Delimiter
Light intensity date 0 to 255; the pulse duty ratio varies within 0 to 100% expressed in incremental
value of100% divided by 256.
In case of Strobe Mode, the value halves to 128 increments. (0,1,3,5,7,….,255)