Specifications

The product can be used as a conventional 12-V DC or 24-V DC power supply. Continuous and strobe
light options are available in either voltage.
2-2 Voltage Selector
12-V DC or 24-V DC output may be selected using the voltage selector on the back panel. However,
please make sure that the product is turned OFF before switching outputs. The voltage selector has
a locking mechanism that requires the switch itself be lifted up to change voltages. 12V DC output is
from connector L1, and 24V DC from connector L2. (When 12V DC is selected, 12V DC is also output
from connector L2.)
2-3 Continuous Light
Refer to other sections for the settings at # 2, # 3, # 5, and # 6.
DIP switch # 4 is not used for continuous lighting.
The # 5 setting depends on what was set when the power was turned ON. Changes made after the
power is turned ON are ignored.
Light control may be set within 256 levels combining coarse and rotary dials.
Continuous Light Control
Light intensity date: (Coarse x 16 + Fine) x 100/255 [%]
(Note1)
Note: however, that the fine rotary dial controls the strobe delay time rather than light control when DIP
switch # 6 is ON. (Refer to 2-5)
The PULSE WIDTH switch does not work for continuous light.
Terminal Block ON/OFF Wiring
NC
TRIGGER
ON/OFF
GND
When the DIP switch # 5 is "OFF" and the ON/OFF signal is ON, the light turns on.
Conversely, when the DIP switch # 5 is "ON" and the ON/OFF signal is OFF, the light turns on.
ON/OFF input