User's Manual

lit during a call.
The keypad and CID will also illuminate when a call is received.
VMWI / Visual Ringer Indicator on Handset
IMPORTANT: In order to use this unit’s Voice Mail Waiting Indicator (VMWI)
feature, you must subscribe to this service from your phone company.
The VMWI indicator on the top of the handset flashes when you receive a new
message from your service provider. Also, it serves as a Visual Ringer function. It
will flash when there is an incoming call.
Speakerphone Operation
NOTE: If you are using the speakerphone, remain close to handset so the
party you are speaking to can hear you.
If you are using the earpiece and want to switch to the speakerphone, press the
TALK/SPEAKER button, press END button to end conversation.
If you are using the speakerphone and want to switch to the earpiece, press the
TALK/SPEAKER button again, press END button again to end conversation.
Making a Call
1. Press the TALK/SPEAKER button. Dial the desired number.
- OR -
Dial the number first, then press the TALK/SPEAKER button.
- OR -
Press the
caller ID-volume
(
 or ) button to select the desired record, then
press the TALK/SPEAKER button.
2. When finished, press the END button to hang up.
NOTE: You may enter up to 28 pre-dial digits.
NOTE: If you want to delete the pre-dial number you entered, press the
delete/int/conf button until all of the digits are erased.
Answering Calls
1. When the phone rings, pick up the handset and press the TALK/SPEAKER
button.
2. When finished, press END button to hang up.
- OR -
If the auto talk mode is selected, pick up the handset from the charge cradle to
answer the call immediately.
NOTE: Adjust the handset volume by pressing the caller ID-volume ( or )
button during a call.
Call Timer
After you press the TALK/SPEAKER button on the handset, the built-in call timer
shows on the display and counts the length of time of the call in minutes and
seconds.
Auto Standby