User's Manual
Getting started
8
If you have separate wall jacks for each line, mount the telephone base on the wall
as described below.
8. Route the 4-pin gray-color telephone line cord from the Line 1 + Line 2 jack
through the channel as shown in Figure 8, leaving about 2 inches from the end of
the channel for plugging into the wall jack.
9. Plug the 4-pin gray-color telephone line cord into the wall jack on the wall plate as
shown in Figure 9. Align the holes on the telephone with the mounting studs of the
wall plate and slide the telephone base down until it locks securely. Plug the power
adapter into an electrical outlet as shown in Figure 10. Be sure to avoid using an
electrical outlet that is controlled by a wall switch.
10. Plug one end of the 2-pin black-color telephone line cord into the Line 2 jack and
the other end into a dierent wall jack as shown in Figure 10.
11. Neatly tie both the excess telephone line cords with a twist tie so it is held on the
top of the base unit.
12. Press
or as desired. The speakerphone is activated automatically.
13. If you hear a dial tone, the installation is complete.
CAUTION:
1. Use only the power adaptor that came with this unit. Using other power adaptors may damage the unit.
2. To prevent re or electrical shock hazard, do not expose this product to rain or moisture.
Figure 10
desk wall