User's Manual

Answering system
42
Changing the security code for remote access
Your answering system allows you to program a 4-digit security code to get access to
the system through any touch-tone telephone. The default security code is 0000.
1. Press the Menu softkey when in idle mode.
2. Press
/ or use the scroll wheel to select Ans. Sys Setup, then press the Select
softkey.
3. Press
/ or use the scroll wheel to select Mailbox Setting, then press the Select
softkey.
4. Press
/ or use the scroll wheel to select Mailbox 1 or Mailbox 2, then press the
Select softkey.
5. Press
/ or use the scroll wheel to select Security Code, then press the Select
softkey.
6. Enter a 4-digit security code using the dial pad keys, then press the Save softkey to
conrm.
Access the answering system remotely
1. Dial your phone number from any touch-tone telephone.
2. Press
when the system is playing the outgoing announcement.
3. You will be prompted to enter the security code. The default security code is 0000.
4. The system will start playing the remote access menu if the security code is
correctly entered.
NOTES:
1. If your answering system is o, you will not hear your outgoing announcement. The system will answer your
call after 10 rings and then ask you to enter your remote code.
2. An error tone sounds if the entered security code is incorrect.
Remote access commands
Touch-
tone keys
Remote command
1 Replay the current or previous message.
2 Play/stop messages.
3 Skip to the next message.
4 Turn the answering system on or o.
7 Listen to the main menu.
0 Delete the current message.
A convenient wallet card, with instructions needed to operate your answering system
remotely, can be found at the end of this user’s manual.