User's Manual

Getting started
3
Figure 4
desk wall
4. Replace the bracket to the telephone base.
5. Plug the smaller end of the power adapter into the power jack at the back of the
telephone base.
6. Plug the larger end of the power adapter into an electrical outlet not controlled by
a wall switch.
Note that there is 1 power jack and 2 phone jacks at the back of the telephone
base as shown in Figure 3.
If both of your telephone lines are located in one wall jack, go to step 7. If your
telephone lines are in two separate jacks, go to step 9.
7. Plug one end of the 4-pin gray-color telephone line cord into the Line 1 + Line 2
jack at the back of the telephone base as shown in Figure 4.
8. Plug the other end of the telephone line into a telephone wall jack.
Power Jack Line 2 phone jackLine 1 + Line 2 phone jack
Figure 3
DSL lter (not
included) is required
if you have DSL
high speed Internet
service.