User's Manual

Appendix

FCC Parts 15, 68 and ACTA

This equipment is in compliance with parts 15 and 68, FCC Rules and Regulations and the

Technical Requirements for Telephone Terminal Equipment published by ACTA.

On the bottom of this equipment is a label indicating, among other information, the US number

and Ringer Equivalence Number (REN) for the equipment. You must, upon request, provide this

information to your telephone company.

The REN is useful in determining the number of devices you may connect to your telephone line

and still have all of these devices ring when your telephone number is called. In most (but not all)

areas, the sum of the RENs of all devices connected to one line should not exceed 5.

A plug and jack used to connect this equipment to the premises wiring and telephone network

must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A

compliant telephone cord and modular plug is provided with this product. It is designed to be

connected to a compatible modular jack that is also compliant. See installation instructions for

details.

This equipment is not intended to be used with Party Lines. If your home has specially wired

alarm equipment connected to the telephone line, ensure the installation of this product

does not disable your alarm equipment. If you have questions about what will disable alarm

&C#)0'&-12%."-,#*1%!"#$%1&*&06"-&%."'0(-!%"$%(%C#(*)8&+%)-,1(**&$:

If this equipment is malfunctioning, it should be unplugged from the modular jack until the

problem is corrected. Repairs to this equipment can only be made by the manufacturer or

its authorized agents. For information on repair procedures, follow the instructions provided

with the limited warranty. Should your equipment cause trouble on your line which may

harm the telephone network, the telephone company shall, where practicable, notify you that

temporary discontinuance of service may be required. Where prior notice is not practical and

the circumstances warrant such action, the telephone company may temporarily discontinue

service immediately. In case of such temporary discontinuance, the telephone company must: (1)

0$"'01*!%-"1)?!%!"#%"?%,#.6%1&'0"$($!%+),."-1)-#(-.&h%D9E%(3"$+%!"#%16&%"00"$1#-)1!%1"%."$$&.1%

the situation; and (3) inform you of your right to bring a complaint to the Commission pursuant to

procedures set forth in Subpart E of Part 68, FCC Rules and Regulations.

The telephone company may make changes in its communications facilities, equipment,

operations or procedures where such action is required in the operation of its business and not

)-."-,),1&-1%7)16%PFF%i#*&,%(-+%i&5#*(1)"-,:%>?%16&,&%.6(-5&,%($&%&=0&.1&+%1"%(3&.1%16&%#,&%"$%

performance of your telephone equipment, the telephone company must give you adequate

notice, in writing, to allow you to maintain uninterrupted service. This device complies with Part

15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not

cause harmful interference; and (2) This device must accept any interference received, including

interference that may cause undesired operation. This equipment has been tested and found

to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular

installation.

Privacy of Communications may not be ensured when using this product.