User's Manual

5 Things You Should Know “ Things
5-D Battery Replacement
If the IN USE indicator flashes after a few telephone calls even if the
battery was fully charged, replace the battery with a new Panasonic
PQWBTC1461 (P-P504) battery.
This unit will not function during a power failure. To connect a standard
telephone on the same line, use a T-adaptor.
T-Adaptor
To Single-Line
Telephone Jack
Standard Telephone
Telephone
Line Cord
5-E Adding Another Phone
2
Remove the old battery.
Then install the new one.
≥Insert the battery plug into
the connector as shown in
the picture.
≥Be sure wires are free from being pressed by the battery body
or handset cover.
5-C Wall Mounting
This unit can be mounted on a wall.
4
Install screws using
the wall template
below. Connect the
telephone line cord.
Mount the unit, then
slide down.
≥Raise the antenna.
2
1
To Power
Outlet
2
1
To Single-Line
Telephone Jack
Screws
8.3 cm
1
Push the lower side of
the hook (1) and pull
down the hook until it
locks (2), so the tab
holds the handset.
Wall Template
8.3 cm
3
Connect the AC
adaptor.
Tuck the telephone
line cord inside the
wall mounting adaptor,
then push it in the
direction of the arrow
(1 and 2).
≥The word “UP WALL”
should face upward.
5
To charge the battery:
Fit the handset hole in the tab
(1) and fix the charge
contacts (2).
≥Make sure to place the
handset with the keypad
facing down.
≥The IN USE/CHARGE
indicator lights and a
beep sounds.
1
2
Tab
Hole
2
1
Black
Lead
Red
Lead
1
Press the notch on the
handset cover firmly (1) and
slide it as indicated by the
arrow (2).
3
Close the cover. Make sure you charge the new battery
for about 15 hours.
2
Remove the wall
mounting adaptor.
2
11