User's Manual

NSTALLING THE

ANDSET

ATTERY

NOTE:

You must connect the handset battery before use.

1. Push down on the top of the battery compartment cover (located on the

back of handset) and remove the cover.

2. Lift the battery pack and connect its plug to the jack inside the

compartment.

3. Close the battery compartment by pushing the cover up until it snaps into

place.

4. Place the handset in the charging cradle.

Allow handset to charge for 12 hours prior to first use. If you don’t properly

charge the handset, battery performance is compromised.

Remark: The handset is dual-face chargeable. You can place the handset on

the cradle with either one side facing you to proceed charging.

ALL

OUNTING THE

HARGER

NOTE: For the best result, leave the phone on a flat surface during initial charging before you

hang the phone on the wall.

1. Attach the wall mounting pedestal by first inserting the tabs on the open

edge of the pedestal into the slots on the lower portion of the bottom of the

charger. Then push down and snap the pedestal into place.

2. Slip the mounting holes (on the back of the pedestal) over the wall plate

posts and slide the unit down into place. (Wall plate not included).

HANGING THE

ATTERY

CAUTION:

To reduce the risk of fire or personal injury, use only the battery that is

compatible with this unit.

1. Make sure the telephone is not in TALK mode before you replace battery.

2. Remove the battery compartment cover.

3. Disconnect the cord attached to the battery pack from the jack inside the

battery compartment and remove the battery pack from the handset.

4. Reconnect the battery pack and insert it in the battery compartment.

5. Put the battery compartment cover back on.