User's Manual

NSTALLING THE

HONE

Choose the best location to install your base. Your base should be placed on a

level surface such as a desk or table top, or you may mount the base on a wall.

Connect with

power adaptor

and plug it into

an AC outlet

Connect with

telephone line

cord and plug it

into a modular

wall jack

CONNECTING THE AC (ELECTRICAL) POWER

Plug the power supply cord into the power jack on the back of the base and the

other end into an electrical outlet. When the handset is placed on the cradle

the charge indicator turns on to indicate the battery is charging.

CAUTION:

Use only the Input: AC 120V 60Hz Output: DC9V 700mA power

supply that came with this unit. Using other power supplies may damage the unit.

CONNECTING THE TELEPHONE LINE

On the base, plug the one end of the telephone line cord into the jack on the

back of the base and the other end into a modular phone jack.

INSTALLING THE HANDSET BATTERY

NOTE: You must connect the handset battery before use.

1. Push down on the top of the battery compartment cover (located on the

back of handset) and remove the cover.

2. Lift the battery pack and connect its plug to the jack inside the

compartment.

3. Close the battery compartment by pushing the cover up until it snaps into

place.

4. Place the handset in the charging cradle.

Allow handset to charge for 12 hours prior to first use. If you don’t properly

charge the handset, battery performance is compromised.