User's Manual

32
B
ELT
C
LIP AND
O
PTIONAL
H
EADSET
A
TTACHING THE BELT CLIP
1. Insert the sides of the clip into the slots on each side of the handset.
2. Snap the belt clip.
CONNECTING AN OPTIONAL HEADSET TO THE HANDSET
The handset can be used with an optional headset for hands free operation.
1. Connect the headset to the headset jack on the side of the handset. The
handset receiver and microphone are disabled when the headset is
connected.
2. Adjust the headset to rest comfortably on top of your head and over your
ear. Move the microphone to approximately two to three inches from your
mouth.
3. Press the [TALK] button to answer a call or make calls using the headset.
4. To return to normal operation, unplug the headset from the jack.
C
HANGING THE
B
ATTERY
CAUTION:
To reduce the risk of fire or personal injury, use only the battery that is
compatible with this unit.
1. Make sure the telephone is not in TALK mode before you replace battery.
2. Remove the battery compartment cover.
3. Disconnect the cord attached to the battery pack from the jack inside the
battery compartment and remove the battery pack from the handset.
4. Reconnect the battery pack and insert it in the battery compartment.
5. Put the battery compartment cover back on.
6. Place handset in the base or handset charge cradle. If you don’t charge
the handset battery properly (for 12 hours) when you first set up the phone
and/or when you install a new battery pack, the battery’s long-term
performance is compromised.
B
ATTERY
S
AFETY
P
RECAUTIONS
 Do not burn, disassemble, mutilate, or puncture. Like other batteries of