Quick Guide

3
Antenna
Power
interface
i
SD card
IP
Network
Figure 4-2 IPC Interfaces
Network
nterface
5 Device Operation
5.1 Startup and Shutdown
Make sure the cables are connected correctly and the device is grounded properly.
Use a power supply that meets requirements.
5.1.1 Startup
Connect the devices to power to start up the devices.
5.1.2 Shutdown
Click > Shutdown on the screen toolbar in live view page.
CAUTION!
Do not disconnect power when the NVR is operating or shutting down.
5.2 Wi-Fi Configuration
The camera will get online and start live view on the NVR once the NVR and camera
are connected to power. Follow the steps to change Wi-Fi settings.
1. Right-click on the NVR and then choose Menu > Network > Wi-Fi AP.
2. Change settings as needed:
 SSID: MAC address by default, you can change as needed.