Operation Manual

CID088A/03012013
Page 17 of 52
3.7 Sleep mode
To save energy, the payment terminal will switch off the background lighting of the display after one hour
of inactivity and go into sleep mode. You can reactivate the terminal by pressing <OK>. If you do not
press <OK>, the payment terminal will switch off automatically after another hour has passed.
If you want to change the sleep mode time settings of the payment terminal, please contact the CCV
Service Center.
3.8 Use of payment cards
The type of card determines whether the holder should insert or swipe the card.
A payment card with an embedded EMV chip
must be inserted in the chip card reader. The
card must be inserted in the chip card reader with
the chip facing up and towards the payment
terminal.
A payment card with a magnetic strip must be
swiped through the magnetic card reader. The
card must be swiped through the magnetic card
reader with the magnetic strip facing down and
towards the payment terminal.
3.9 Replacing a printer roll
Complete the following steps to replace a printer roll. Always be careful during this procedure! The
cutting edge is sharp and the printer may be hot.
1. Press the release button and open the
printer cover. Remove the old printer roll.
2. Insert the new printer roll as indicated in the
above photograph. Make sure to leave a
strip of paper sticking out and close the
printer cover. Tear off the strip of paper
along the cutting edge.