Specifications

33
MODELS WITH TILTING GRILL AND WIRE RACKS
• TOP OVEN: See chapters “MODELS WITH WIRE RACKS” at page 32 and
“MODELS WITH TILTING GRILL ON THE TOP OVEN at page 38.
• BOTTOM OVEN: Operate as follows:
– Assemble the wire racks on the oven walls using the 2 screws (fig. 4.4). In the models
with catalytic panels interpose the catalytic panels “A” with the arrow up (fig. 4.4).
Models with side lamp on the bottom cavity: The catalytic panel with the hole for
the side oven lamp must be positioned on the left oven wall. DO NOT INTERPOSE
THE CATALYTIC PANEL WITHOUT THE HOLE ON THE LEFT OVEN WALL.
– Slide in, on the guides, the shelf and the tray (fig. 4.5).
The rack must be fitted so that the safety catch, which stops it sliding out, faces
the inside of the oven.
To dismantle, operate as follows:
– Unscrewing the fixing screws and slide off the wire racks and the catalytic liners (if
supplied) to the oven wall as in fig. 4.4.
The grill is secured to the rear wall of the oven on a hinge system that allows
it to be lowered to allow proper access when cleaning the oven ceiling (fig. 4.6).
Fig. 4.6
Fig. 4.4
A
A
Fig. 4.5
BOTTOMMAINOVEN ONLY
HOLE FOR SIDE LIGHT
(SOME MODELS ONLY)
SIDE LIGHT
(SOME MODELS ONLY)