Specifications

51
5
INSTALLATION
Fig. 5.1
IMPORTANT
• The appliance should be installed by a QUALIFIED
INSTALLATION TECHNICIAN.
The appliance must be installed in compliance with regulations in force.
You need the following housing area to fit your oven correctly.
The double oven is designed to fit into a cabinet of 600 mm width.
The double oven can be built in the kitchen units, but you must ensure that it is properly
ventilated.
In the diagram the appliance is ventilated by means of the space in the top of the
kitchen cabinet.
Lift the appliance into position onto the shelf, taking care NOT to lift it by the door handles.
If you open the oven doors, you will see some screw holes.
The oven should then be secured to the housing by fitting screws into these holes.
Remember the housing should not be free standing but be secured to the wall and/or
adjacent fittings.
Adjust the hinges of furniture door adjacent to the double oven to allow a 5 - 7 mm
gap between the furniture door and the oven frame.
WARNING
• We would point out that the adhesive
which bonds the plastic laminate to the
furniture must withstand temperatures not
less than 150° C to avoid delamination.
• The appliance must be housed in heat
resistant units.
• The walls of the units must be capable
of resisting temperatures of 75 °C
above room temperature.
WARNING
When correctly installed, your product
meets all safety requirements laid down
for this type of product category.
However special care should be taken
around the rear or the underneath of the
appliance as these areas are not
designed or intended to be touched and
may contain sharp or rough edges, that
may cause injury.
560
50
877
888
min.
555
536
595
564
Dimensions (mm) Oven Housing
Height 888 877
Width 595 560
Depth 564 555 min.