Product specifications

Alarm and Event
80 3BDS011222-510 B
group of controller in for example the Alarm Filter. In this way you may have
different alarms and/or external alarm for different Process Sections.
When you filter an alarm, you may choose which Process Section this alarm list will
cover. This is configured below the Area tab, in the Process Section area.
If you do not use Process Sectioning or your controllers do not support it the default
All setting shall be used.
Class. In the Class area you may select if you want:
• All - all classes will be selected.
• Range - all classes in the chosen interval will be shown.
• Range Expressions - chosen classes and/or class ranges will be shown. (Enter
them separated by commas, for example, 10,20,30-60).
Filtering Alarm Messages
To filter Alarm Messages, follow the steps below:
1. Select Alarms in the Source area.
2. Select the alarm message states, below the Condition State tab, to be included
in the list.
– Active State
Choose to show Active/Inactive alarms or both.
– Enable State
Choose to show Enabled/Disabled alarms or both.
– Acknowledge State
Choose to show alarms that are acknowledged or not, or both.
– Auto Disable State
Choose to see all auto disabled alarms (alarms that are disabled in the
controller), or Not Auto Disabled.
Observe that the used controller(s) must support Process Sectioning. For more
information, refer to the controller documentation.