Integrated Dishwasher CW493 BL/WH/SS Users Operating Instructions Before operating this appliance, please read these instructions carefully
Guarantee CDA appliance carry a five-year parts and one-year labour guarantee. CDA will repair or replace any defect or part attributable to faulty material or workmanship. Within the first year this will be free of both labour and parts charges. After the first year and within five years, the parts will be supplied free of charge provided that the repair is carried out by an agent authorised by CDA and the labour will be charged at the commercial rate applicable at the time of repair.
Safety Is Very Important GB IMPORTANT Carefully read the instructions contained in this manual, as it pro- * If the appliance is not operating properly or, requires maintenance, disconnect the appliance from the power supply. vides information that is essential to safe and proper installation, use and maintenance of this appliance. - Keep detergents out of the reach of children. Also keep children away from the dishwasher when it is open to reduce the risk of injury.
Close-up View (Interior) A B C D GB E F G H I Upper Rack Rack Height Adjustor Top Spray Arm Lower Rack Bottom Spray Arm Washing Filter Detergent and Rinse Aid Dispenser Salt Container Cap Third Sprayer Technical Characteristics Width 60 cm Depth 58 cm Height 82 cm 12 standard place settings Capacity Mains water pressure 0.03-0.6 MPa Power voltage 220-240V~ 50Hz Total absorber power 2150W .2.
Salt...... GB Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes Adjusting Salt Consumption The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
Detergent and Rinse Aid...... GB Detergent Rinse Aid Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the wash cycle following the instructions provided in the "Wash Cycle Table.
Loading the Dishwasher GB Before placing the dishes in the dishwasher, remove larger food Lower Rack particles to prevent the filter from becoming clogged, which results in reduced performance. Upper Rack If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed. This will eliminate the need for extra wash cycles. Pull out the rack to load the dishwasher.
Turning on the Appliance GB Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the susceptible to breakage. They will also dry better. Dishwasher" on page 5).
Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the soak GB - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater negative impact on the environment. cycle.
Wash Cycle Table Cycle Eco Button Rapid Button GB Cycle Selection Information Description of Cycle Deter- Rinse gent Aid Pre-wash with hot water. Very dirty dishes, pots and Rinse with cold water. Intensive pans (not to be used with Extended wash at 60 K Wash delicate items). Intensive Very dirty dishes, pots and pans. (not to be used with delicate items) and pans. Standard daily Normal cycle. Wash and pans. Standard daily Normal Wash cycle.
Cleaning and Special Maintenance GB Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the "A" semi-circular filter and cup under running water.
Installation GB Positioning the Appliance Hot Water Connection Position the appliance in the desired location. The back should The water supply to the appliance can also be connected to the rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply house's hot water line (centralised system, heating system), as long as it does not exceed a temperature of 60 .
Assembly Instructions for Integrated Dishwasher GB Fastening the Bracket to the Wooden Panel(Fig.4 integrated with control panel) Technical Information for Installation The control panel can be easily aligned with the kitchen drawers, using the spacers supplied with the appliance (see Fig.1 and At the point marked, drill holes 2 mm in diameter . If the panel is made of chip board , only drill through the veneer. If the panel is Fig.2).
Assembly Instructions for Integrated Dishwasher GB Adjustment of Back Feet (Fig.6A) How to use water-proof plastic Insert the appliance in the cutout and then adjust the height of Firstly take off the water-proof plastic from the sticker with the the machine using the screws located at the bottom front .Use a screwdriver to turn the screws in a clockwise direction to raise appliance (see I=Fig.9). Secondly stick it on the bottom of the kitchen board (see I=Fig.9).
Assembly Instructions for Integrated Dishwasher NNR NPTKR GB Fig.4 Fig.1 2-7Kg Fig.5 _ Fig.2 mm 115 122.5 130 137.5 145 152.5 _ m m 115 2.5 12 ^ 0 13 7.5 13 5 14 2.5 15 58 432mm 436mm 440mm 444mm LARGH.=448mm m m 115 2.5 12 m m 6m m m 58 0m m 59 4m 8m 59 .=59 H RG LA 2m m 8m 59 H.= mm RG 594 0mm m LA 59 6m m 58 2m 58 0 13 7.5 13 5 14 2.5 15 58 ^ m m 6m m m 58 0m m 59 4m 8m 59 .=59 H RG LA 2m 2Kg m 8m 59 H.= mm RG 594 0mm m LA 59 6m m 58 2m 58 7Kg LARGH.
Assembly Instructions for Integrated Dishwasher Fig.7 GB Fig.8 ^ UM M SMM UOM SMMJTM RUM Fig.9 Fig.10 .14.
Installation GB Diagram WR 3(1) 1(3) IG LS IS 1 L N 4(2) 220-240V~ 50Hz 1 LSB 2 3 2(4) LSS B1 B5 F CL CL 8 TS.50 n.a. 7 A5 A4 Filter B2 B3 B3 B4 A3 TS.58 n.a.
Appliance servicing CDA provide a quality and effective after-sales service to cover all your servicing needs. Please attach your receipt to this page for safekeeping. Please help us to help you by having the following information available when booking a service call. 1. Model type, make and model – see the front of this manual 2. Evidence of installation/purchase date 3. Retailer where the appliance was purchased 4. Clear and concise details of the fault 5.
