FF850 freestanding combination fridge freezer Manual for Installation, Use and Maintenance Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified personnel.
Before first use of the fridge You must allow the fridge to settle for at least twenty four hours prior to switching the power on. It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm water and then thoroughly drying the interior. The fridge may have an odour to it at first use. This will disappear as the appliance cools.
Setting the temperature Both compartment temperatures are regulated by the same thermostat dial, which is found to the right of the control panel at the top of the door frame when the fridge door is open. The thermostat can be moved between 1 (least cold) and 5 (coldest). Thermostat settings: 1-2 For short term storage of food 3-4 For long term storage of food 5 For freezing fresh food. Once the food has been frozen, the thermostat should then be turned back to the required setting between 1 and 4.
Defrosting the freezer Do not use heaters or defrosting sprays in this appliance. • Never use any metallic or sharp objects to remove the ice as this could damage the lining. • The freezer compartment should be defrosted regularly to ensure the most efficient running of the freezer. • Once the ice is more than 5 mm thick, the freezer must be defrosted. • First remove the two lower freezer drawers. • To speed up the process, put a bowl of warm water in the base of the freezer compartment.
Changing the light bulb Disconnect the appliance from the power. • Remove the light cover by pressing on the hooks on both sides of the cover. • Unscrew the light bulb to remove it and replace with a new bulb (not more than 15W). • Replace the light cover and reconnect the power. This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places. • The plug should be fully accessible at all times.
Electrical information Warning! this appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover. Important: do not use the appliance without the fuse cover in position.
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.
VESTEL WHITE GOODS VESTEL REFRIGERATOR CUSTOMER SUPPORT ASSEMBLE & DISASSEMBLE A- Changing The Door Swing Direction to Right Hand 1- Unscrew the two screws which are fixing the middle hinge. (Fig-1) Also remove the two middle hinge screw caps (big) on the left side. Remove the two middle hinge screw caps (big) Figure -1 2- Dismantle the refrigerator and freezer door from cabinet by pulling towards to you together with the middle hinge. (Fig-2) Figure -2 3- Remove the kick plate by pulling forward.
VESTEL VESTEL REFRIGERATOR WHITE GOODS ASSEMBLE & DISASSEMBLE 4- Place the two middle hinge screw caps (big) as shown in the figure. (Fig-4) You can find the new caps in the user manuel bag. CUSTOMER SUPPORT 5-Unscrew the pin of the top hinge. (Fig-5/Detail-A) and screw it to the left hinge. (Fig-5/Detail-B) DETAIL-B DETAIL-A Insert the two middle hinge screw caps (big) here Figure -5 Figure -4 6- Replace the top bushing and top bushing cap.
VESTEL WHITE GOODS VESTEL REFRIGERATOR CUSTOMER SUPPORT ASSEMBLE & DISASSEMBLE 7- Replace the top bushing and top bushing cap. (Fig-7) (You can use the bushing cap that is put in the user manual bag) Remove the bottom bush and reassemble it to the left side. (Fig-7) Detail-A Freezer Door Figure -7 8- Turn the middle hinge 180º clockwise direction. Assemble the freezer door and refrigerator door together with middle hinge. (Reverse operation of item 2) Fix the middle hinge by tighting the screws.
VESTEL VESTEL REFRIGERATOR WHITE GOODS INSTRUCTIONS CUSTOMER SUPPORT A- Thermostat Knob DISPLAY PANEL ORANGE GREEN RED THERMOSTAT KNOB 3 2 1 You may adjust freezer temperature automaticaly by thermostat knob. If you turn the thermostat knob to ‘’0’’ position, freezing will be stopped. Positions of thermostat knob; 5: Is a SUPER FREEZING position.When a lot of food is placed inside the appliance, adjust the thermostat knob to super freezing position (5).
