Troubleshooting guide

9
Installing the wine cooler
This appliance is intended to be installed in a space
between two units.
The minimum space required is:
FWC152 – 150 mm wide x 555 mm deep x 825 mm high
FWC302 – 300 mm wide x 580 mm deep x 825 mm high
FWC602 – 600 mm wide x 580 mm deep x 825 mm high
FWC622 – 600 mm wide x 580 mm deep x 825 mm high
Please note: When the product is installed, there should
be a small ventilation gap between the top of the unit
and the underside of the worktop (6 mm or ¼”)
These products should not be installed:
1. In direct sunlight.
2. Adjacent to a heat source (oven or radiator).
3. Below a hob unit.
4. Where a continuous plinth is to be used, it is necessary
cut a section out so that the ventilation slots at the
front of the appliance are not obstructed in any way g 6.
IMPORTANT: Failure to follow the instructions regarding
installation and ventilation may invalidate the warranty
supplied with your appliance.
To install the handle
IMPORTANT: Do not overtighten the screws, and do not use power tools to install the handle.
1. Carefully locate the handle over the xing pins.
2. Using the supplied allen key, tighten the securing grub screw to x the handle.
IMPORTANT: Take care when installing the handle not to damage the door. Any damage caused may not be covered
by the warranty supplied with your appliance.
g. 6