Ceramic Griddle Users Operating Instructions Before operating this hob, please read these instructions carefully
Dear Customer, Thank you for choosing one of our products. The warnings and tips given below are intended to protect your safety and that of others. They will also help you make the most of your appliance. Keep this booklet in a safe place. It will be useful if you, or anyone else, have any questions about use of the appliance. This appliance must only be used for the purpose for which it was designed, i.e. for cooking foods. Any other use should be considered incorrect and therefore dangerous.
IMPORTANT WARNINGS AND TIPS ✓ When unpacking the appliance make sure that it is not damaged. If you have any doubts, do not use the appliance but consult your supplier or an engineer. ✓ The packing materials (plastic bags, expanded polystyrene, nails, bands etc.) must not be left within easy reach of children, because they are a possible source of danger. ✓ The packaging material is recyclable and is marked with the recycling symbol .
Ceramic Griddle Figure 1 1 2 3 FEATURES - Electrical insulation Class I. COOKING POINT 1. Hot plate - 1300 W CONTROL PANEL DESCRIPTION 2. Hot plate control knob 3.
Use of Ceramic Griddle HOW TO USE THE COOKER TOP Figure 2 The griddle reaches the working temperature very quickly and can grill any food, without fat and oil, directly on the radiant zone's glass-ceramic surface. Operation of the radiant zone is controlled by a continuous 12-position power regulator. The signal lamp lights up when the griddle is ON. USING THE GRIDDLE FOR THE FIRST TIME ✓ Remove the adhesive film which protects some parts.
USE OF THE GRIDDLE ✓ Before cooking make sure that the radiant zone is clean. ✓ Switch the griddle on by turning the knob to position 12. ✓ Preheat until the cooking surface becomes red. ✓ Then turn the knob to the position required. The numbers from 1 to 12 indicate the working positions with temperature increasing as the number increases. ✓ Place the food on the radiant zone and check the cooking by eye. ✓ Turn off the griddle by turning the knob to position “0”.
Cleaning and Maintenance GENERAL TIPS ✓ Before you begin cleaning, you ✓ ✓ ✓ ✓ must ensure that the hob is switched off. It is advisable to clean when the appliance is cold, especially when cleaning the enamelled parts. Avoid leaving alcaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces. Avoid using cleaning products with a chlorine or acidic base. Do not use a steam cleaner because the moisture can get into the appliance and make it unsafe.
Installation Instruction Figure 3 TECHNICAL INFORMATION FOR THE INSTALLER ✓ Do not instal the appliance near inflammable materials (eg. curtains).
Figure 5 FASTENING THE APPLIANCE A A ✓ Cut the unit (as shown in figure 3). A A ✓ Stretch gasket “D” over the edge of the hole made, being careful to overlay the junction edges. ✓ Turn the ceramic griddle over and put tabs “A” into the mountings, only tighten screws “B” a few turns (fig. 6). Make sure that the tabs are mounted correctly as shown in the figures. Turn the tabs so that the cooktop can be put into the hole.
Electrical Section IMPORTANT: Installation must be carried out according to the manufacturer's instructions. Incorrect installation may cause harm and damage to people, animals or property, for which the manufacturer accepts no responsibility.
Figure 7 Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains. REPAIRS A Replacing the supply cable Turn the cooktop over and unhook the terminal board cover by inserting a screwdriver into the two hooks “A”. Open the cable gland by unscrewing screw “F”, unscrew the terminal screws and remove the cable. The new supply cable, of suitable type and section, is connected to the terminal board following the diagrams shown below.
Rif. 1565 Ceramic Griddle Cod.
