HVC60 / 70 / 90 Ceramic Hobs Manual for Installation, Use and Maintenance Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment.
Please note: Before operating this hob, please read the instructions carefully After unpacking the appliance, make sure it is not damaged. In case of doubt, do not use the appliance and contact your supplier. Remove all packaging and do not leave the packing materials in easy reach of children as they may cause serious injury. The packaging materials are recyclable. Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance.
Using your hob HVC60 Zones: 1. Front left 1.2 kW 140 mm 2. Rear left 2.3 kW 210 mm 3. Rear right 0.75/2.2 kW 120/210 mm dual 4. Front right 1.2 kW 140 mm Control panel: 5. Front left zone control 6. Rear left zone control 7. Rear right zone control 8. Front right zone control 9. Residual heat indicators 10. Power indicator light 2 3 1 4 5 6 7 9 8 10 Fig.1 HVC70 Zones: 1. Front left 1.2 kW 140 mm 2. Rear left 0.8/2.2 kW 180x260 mm oval dual 3. Rear right 1.2 kW 140 mm 4. Front right 0.75/2.
How to use the hob The ceramic surface of the hob allows fast transmission of heat vertically from the heating elements under the glass to the pans on the hob top. The heat does not spread horizontally, so the hob top remains relatively cool only a few centimetres from the zone in use. Please note: The heating elements are equipped with a temperature limiter that will switch the element off to prevent damage to the hob.
How to use the hob Cooking zone settings TYPE OF COOKING Cooking zone setting 0 Switched OFF 1 2 For melting operations (butter, chocolate). 2 3 4 To maintain food hot and to heat small quantities of liquid (sauces, eggs). 4 5 6 To heat bigger quantities; to whip creams and sauces. (vegetables, fruits, soups). 6 7 Slow boiling, i.e.: boiled meats, spaghetti, soups, continuations of steam cooking of roasts, stews, potatoes. 6 7 For every kind of frying, cutlets, uncovered cooking, i.e.
Efficient Use of your Hob The hob is equipped with zones of different sizes, designed to accommodate most shapes and sizes of pan. For best results, only use pans with flat bottoms and choose an appropriate zone depending on the size of the pan. The most efficient use of the hob is shown below, where the pan and zone are correctly chosen. Use pan lids where possible to minimize the energy usage of your appliance.
Care and Maintenance Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. You should use a non-abrasive cleaner to clean the hob top. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. Do not use steel wool, abrasive sponges or sharp utensils such as knives to clean the hob as these could damage the hob. The hob surface and the pans must be clean.
Mains Electricity Connection Warning! this appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. C This appliance is intended to be connected to fixed wiring and is not suitable for connection to a 13A plug or 13A supply. A This appliance is intended to be connected to fixed wiring by a double pole switch, having a contact separation of at least 3mm in all poles.
Fitting the Hob Unpacking the hob: • Take care not to lose or mishandle any parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 190mm away from any adjacent vertical surfaces, e.g. a tall cupboard end panel. This may be reduced to 100mm if the adjacent surface is resistant to fire (tiles or steel, for example). These dimensions are shown in Fig.12.
How to Install the Hob How to install the hob: Overall dimensions of the hob: HVC60 Width 590mm Depth 510mm HVC70 Width 770mm Depth 510mm HVC90 Width 900mm Depth 510mm Worktop cut-out dimensions: HVC60 Width 560mm Depth 490mm HVC70 Width 740mm Depth 490mm HVC90 Width 870mm Depth 490mm 1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance. The cut-out (Fig.
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.
