Operating instructions

Section 3
Installation
1. Introduction
2. Inspection
3. Safety During Installation
4. Installation Tips and Hints
Cl NO<dson Corporanon 1993
AI R oghls R esO<Ved
Installation 3-1
This chagter includes information on inspe~ing and i_nstalling the
Nordson
PC40 Pattern Control and assoc1ated equ1pment:
•
the gun solenoids,
• the Nordson Sensors,
• the Nordson Remote Memory Select Switch, and
• the Nordson Keyed Lock Out Switch.
After unpacking, check that you have the pattern control and other
equipment that you ordered (see
Section 6 for part number
information).
Inspect all components for dents, cracks, scratches, or
other evidence of physical damage. If you find any damage, contact
your Nordson sales representative before installing the equipment.
WARNING: Personal injury hazard. Failure to review the
safety information in
Section 1, Safety Summary, of this
manual can result in equipment damage, personal injury
or
death. Before installing this equipment thoroughly review
Section 1. Also, follow the specific safety pr ecautions in this
section.
Wire Gauge
The table below specifies the proper gauge wire for the various
electrical connections, regardless of the wire length.
Table 3. 1 - Recommended Wire Guages
Connection Wire Gauge
AC 14-16
Solenoids 16-18
Remote Memory Select Switch and
18-22
Keyed Lock Out Switch
P IN 108 389A
57 · 28 1/93