Operating instructions

3-18 Installation
Mounting Nordson Sensors
(continued)
3. Locate the sensor bracket so that the sensor Is no closer than 2 in.
(5.1 em) nor further than 15 in. (38.1 em) from the substrate.
4. Securely connect the sensor bracket to the mounting surface.
Excessive movement
or vibration can result in intermittent or false
operation caused
by loss of alignment to the substrate.
5. Using the two mounting bolts provided with the sensor bracket,
secure the sensor to the bracket (Figure 3.13).
Figure 3.13 - Connecting the sensor and bracket
1 -
114 mounting bolts (2 supplied)
2 - Bracket
3 -Lens centerline, 1. 12 in. (28.5 mm)
4
-Front of sensor tilts vertically
+I- 15 degrees from horizontal
PIN 108 38!1A
57 ·U I/SI3
6. Route the sensor leads through water-tight conduit (for an IP-54
enclosure rating} and the strain relief connector and into the PC40.
7. Skip to "Nordson Photosensor Wiring Connections."
o Norason Corporallon 1993
All A ogh ts Aoservoa