Operating instructions

4-22 Operating Instructions
Programming Transition
(continued)
PIN 108 389A
57·28 1/93
Setting the Transition Value
Push Button Sequence Result
1. Press LEFT or RIGHT to
1.
The selected digit is flashing on the LCD.
select a digit position.
2. Press UP (to increase the digit
2.
The digit value increases or decreases.
value) or press
DOWN (to
decrease
the·value).
3. Repeat the steps 1 and 2 until
all the digits are set to the
value you want.
4. Press
SET. •
The value is entered into memory .
• The program moves to the next transition
symbol to the right (which is flashing; and
the current value for the transition is
displayed),
or
• If this is the eighth or last configured
transition, the program moves to
"X",
which is flashing on the Transition level.
5. Repeat steps 1 though 4 until
you have the values that you
want for
all the transitions.
Implementing Transition Changes Between Patterns
You may want to enable changes to these values between patterns in
set-up or during intermittent operation.
Push Button
Sequence
1. Repeat the steps in "Selecting a
Transition" and
"Setting the Transition
Value
."
2. Press the Nordson Oval.
Result
1. The transitions are set to new values.
•
.
The pattern in p ro gress is
interrupted.
Operation resumes (using the new
values) when the next trigger
signal is received.
Nordson Corpor at Kin 1993
All At gh ts Reserved