Operating instructions

Programming Transition
(continued)
Programming Stitch
No rdson Cotporatoon 1993
AU Aoghl.s Reserved
Operating Instructions 4-23
Moving to the STITCH Selection Level
Push Button Sequence
Result
1. If "X: is not flashing on the Transition
•
The transition symbols flash as
level, press LEFT or RIGHT.
you press LEFT
or RIGHT
•
"X" is flashing on the Transition
level.
2. Press DOWN. (1)
• The stitch symbol is displayed
constantly (not flashing).
•
"X" is flashing on the Stitch
selection level.
Ill The program will not allow you to access Stitch mode if you selected Stitch Off
in the Configure mode. Refer to "Configure Mode" later in this section.
NOTE: The program will not allow you to access St itch mode if you
selected
Stitch Off in the Configure mode. Refer to "Configure Mode"
later in this section.
Default Display
0
(FLASHING)
Deactivating Stitch
NOTE: Deactivating stitch turns stitching off for the channel that you
are programming. However, the values for
% coverage and bead length
are still saved in memory for later use if you reactivate stitch for this
channel.
Push Button
Sequence
1. Press LEFT or RIGHT to
move to the stitch off symbol.
2. Press SET.
Result
1.
The stitch off symbol is flashing:
(flASHING) I· 0
I
.
The stitch off symbol is displayed
constantly (not flashing).
• "X" is flashing on the Stitch level (see the
default display above).
PIN 108 389A
57 -28 1 /93