Operating instructions

4·26 Operating Instructions
Programming Stitch
(continued)
PIN 1 08 389A
57·28 1/93
Determining Stitch Bead Length
This setting defines the length of each st itch bead that wi ll be deposited
during each
st itched duration. You can set the length from 0 to 1.023
seconds per bead.
Similar to setting % values, selecting a very small stitch bead value will
result in an almost continuous bead and may exceed the mechanical
response time capabilities
of the gun and solenoid. Depending on how
large a stitch bead value is selected, you may have only one bead
deposited during any duration.
To achieve a useful stitch pattern, Nordson recommends that you begin
with a stitch bead that equals
1 15 of the duration length (unless you
have other specific requirements). For example, a
0.500 second
duration should have
no more than a 0.1 00 second stitch bead lengths.
Based on test patterns, you can then increase
or decrease the bead
length to suit your application.
Entering Bead Length Values
Push Button Sequence Result
1. Press LEFT or RIGHT to
select a digit position.
2. Press UP (to increase the digit
va lue) or press DOWN (to
decrease the value).
3. Repeat the steps 1 and 2 until
bead length is set
to the value
you want.
4.
Press SET.
1. The selected digit is flashing on the LCD.
2. The digit value increases or decreases.
4.
"X" is flashing on the Stitch level.
Nordson Corpora110n 1993
All Roghls R esetved