Operating instructions

6. Run Mode
Purpose
Accessing Run Mode
Resetting the Pattern
Operating Instructions
4-27
Run Mode enables you to
• reset the pattern and to
• review the programmed parameters and values.
This is the
PC40 operational mode. You must be in this mode in order
to access any other mode or to view program parameters.
After start-up, the
PC40 automatically defaults to th is mode. The unit
returns
to this mode whenever:
• SET is pressed while ·x· is flashing in any selection level,
•
there is a 10 minute period in which no push buttons are pressed.
Press the Nordson
Oval to reset the pattern. The pattern will restart
when the
PC40 receives the next trigg er signal.
Reviewing Parameters and Values
The selections programmed for each available memory can be
reviewed in the Run mode.
Selection Level
Memory
Channel
PIN 108 389A
57 ·28 1/93
Parameter Review Sequence
Push Button Sequence
1 . Press DOWN.
2. Press LEFT
or RIGHT until
the memory symbol that you
want
to review is flashing.
3. Press
SET.
4. Press LEFT or RIGHT until
the channel symbol that you
want to rev
iew is flashing.
5. Press SET.
Result
1.
The LCD displays the active memory; ·x·
is flashing on the Memory level.
2. The selected memory letter is flashing.
• The selected memory letter is
displayed constantly on (not flashing).
• The active channel numbers for this
memory are displayed.
•
·x · is flashing on the Channel level.
4. The selected channel number is flashing
•
•
•
•
and the memory letter is displayed.
The selected memory letter is
displayed.
The channel number is displayed .
The trigger and edge symbol are
displayed.
The transition symbols are displayed
and
·x· is flashing on the Transition
selection
level.
C No rdson Co r po ration 1993
All A•ghts Reserved