Operating instructions

4-28 Operating Instructions
Reviewing Parameters and Values
(continued)
Parameter Review Sequence (continued)
Selection Level
Transition
Stitch
Move to any other selection
level, or exit parameter review.
Cl Nord so n Co rporabon 1993
AU Rights Reserved
Push Button Sequence
6. Press LEFT or RIGHT until
the transition symbol that you
want to review is flashing.
7.
To view other transitions,
repeat step
6.
8. To view the Stitch level:
a. Press LEFT or RIGHT until
"X" is flashing on the
transition
level.
b. Press DOWN.
9. If stitching was deactivated in
the Program mode for the
channel you are reviewing, do
one of the following:
a. Press UP to move to any
previous
level.
b. Press SET to exit the
parameter review.
1 0. If stitching was activated in
the Program mode for the
channel you are reviewing:
•
Press LEFT or RIGHT to
move to the stitch
percentage
or bead length
symbol.
11 . When you are finished
viewing the
Stitch level, do
one
of the following:
• Press UP to move to any
previous
level.
•
Press SET to exit the
parameter revie
w.
Result
6. The selected transition symbol is flashing
•
•
•
•
.
•
and its value is displayed.
The stitch symbol is displayed and ·x·
is flashing on the Stitch level.
•x• is flashing on the selected level.
The program returns to the default
(Run) mode.
The selected symbol is flashing and its
value is displayed.
· x· is flashing on the selected level.
The program returns to the default
(Run) mode.
P/N 108 389A
57·28 1193