Operating instructions

7. Configure Mode
Purpose
Accessing Configuration Mode
LOCK
CONFIGURE
PROGRAM
RUN
TEST
MEMORY
CHANNEL
TRIGGER
TRANSITION
STITCH
Figure 4. 18- Configuration mode defaults
1 - ·x· flashing
Changing Selection Levels
Exiting Configure
P/N 108 389A
57-28 1/93
Operating Instructions 4·29
CAUTION: Removing memories in Configure mode erases
all parameter values for those memories. Removing
parameters can erase programmed values for some
or all
memories and/or channels. Only the parameters you select
in Configure
will be accessible in the Program and Run
modes. Nordson recommends that Configure mode be
utilized
only in initial set-up or for intended system
modification. To routinely activate and deactivate
parameters, use the Program mode.
This mode gives you the ability
to :
• select the number of memories available for programming, and to
• select the parameters available for programming.
Press the Nordson
Oval and SET buttons at the same time. The
Configuration mode display is shown (Figure 4.18).
A
1
1
8 C D X+:-:----1
2 3 4
2 -II II-
•
While •x• is flashing, press DOWN or UP.
While ·x· is flashing, press SET.
C Nordson CorporatiOn 1993
AJI
Al ghto Reserved