Specifications

Regulation of Air Supply to Oven and Grill Burners

To regulate the air supply it is necessary to remove the burners from their housings (gs. 39 - 41).

− Using a cross-head screwdriver, slacken the screws “A” securing the air ow regulation collar “B”

(g. 42) and move the collar forward or backward to increase or reduce the air aperture in accor-

dance with gas type and the indications in the ‘Table for the choice of the injectors’.

 IMPORTANT: If the air ow regulation collar “B” is not already tted on the burner (e.g. oven burner

set in the factory for LPG use), it is supplied with the kit for the gas conversion. In this case the air

ow regulation collar “B” shall be tted as indicated in gure 42:

– the collar “B” shall be folded around the burner (one half part at the top and one half part at

the bottom);

– the throttled section shall be oriented toward the burner deector (opposite side with re-

spect to the injector).

− Replace and light the burners to check the ames.

1 2

Fig. 42

Grill burner

Oven burner

Ring opening [mm]

(see the “Table for the choice

of the

injectors”)