th100 Three in One Instant Hot Water Tap Installation, Use and Maintenance Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu www.cda.
Safety Instructions The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Do not wash your hair, babies, children or pets in any sink within reach of this appliance.
This appliance can be used by children aged from 8 years and above if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazard involved. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of the reach of children aged less than 8 years.
• Never touch the under-counter parts of the appliance with damp hands. • Never touch the plug with damp hands. • Make sure the socket used is freely accessible at all times, enabling the appliance to be unplugged when necessary. • Unplug directly from the plug only. Never pull the power cable as you could damage it. • If the appliance is faulty, do not attempt to repair it; unplug from the mains electric socket and contact the dedicated hot tap Customer Care line (details on back cover).
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. The guarantee may become void in the event of the water filter not being replaced at the required six month intervals.
CE Declarations of Conformity: This oven has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006/95/EEC (Low voltage) and requirements of EMC Directive 2004/108/EEC. This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical safety (LVD) and Electromagnetic interference compatibility (EMC). Parts intended to come into contact with food conform to EEC/89/109.4.
Using Your 3 in 1 Instant Hot Water Tap Control Panel G F H E D C A Fig.
To switch the instant hot water heater on or off Touch the “On/Off” key (A) once to switch the water heater on. Touch the “On/Off” key (A) once again at any time to switch the water heater off To set the water temperature Touch the “Temperature” key (C) several times to scroll through the available temperatures. When the “Set temperature” indicator (G) shows the temperature you want, touch the “Confirm” key (A) once to confirm this setting.
Care and Maintenance IMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING OF THE RESERVOIR/HEATER UNIT WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. Cleaning You should use a non-abrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings.
Troubleshooting Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact the dedicated hot tap Customer Care line (details on back cover). Problem Remedy “Set temperature” indicator flashes “99”. Insufficient water in Prime the installation as the tank. described in the installation instructions below. Water and Steam is spitting from the instant hot water tap spout. Unit is boiling. Turn the instant hot water tap handle on and release the water.
Problem Possible Cause Remedy Water drips from the 3 in 1 instant hot water tap spout. The expansion chamber isn’t draining the system correctly due to very small draw off of water. Draw off 0.5L of water to clear and prime the system. Avoid drawing off less than 150mL of water at a time. The spout is blocked. Remove and clean the aerator on the tap. Slow Flow from the spout. The water filter may be clogged from impurities in the inlet mains water. The water filter must be changed every 6 months.
Installation It is the installer’s responsibility to ensure that your 3 in 1 instant hot water tap is fitted in accordance with all prevailing national standards and local water byelaws. It is important to ensure that the plumbing part of the installation is completed and has been tested to ensure it is free of leaks, before any electrical connection is made to the unit. Do not install the appliance in rooms where the temperature may drop to 0°C or lower.
• All parts should be removed from their packaging and inspected for any transport damage prior to installation. • Shut off your water heating system and ensure that your mains stopcock is closed. Open the lowest hot and cold taps in the house and allow the water to run until the cold-water storage tank and pipes are fully empty. Please note, the hot water storage cylinder (if applicable) will always remain full.
• A ccess to any stopcocks, valves, waste traps or other plumbing fittings that may require service is not impeded. • The front display and operating controls are readily accessible and visible. • All connection pipes can be installed without stretching or twisting of them. • Access to the electric power socket to be used for this appliance is not restricted in any way. • There is a fused 13A power supply within reach of the power cable, with that cable supported for its full length and not stretched.
30m 225 2 CTRS m 325mm G3/8" OUT TO HEATER TANK THROUGH FILTER O35mm HOLE G1/2" DOMESTIC HOT IN (RIGHT HAND HOSE) RED G1/2" COLD IN (HOSE AT REAR) BLUE O5 I.D SILICONE TUBE FROM TANK Fig. 2 • P ush the supplied copper stub pipe/⅜”BSP adaptor into the water inlet of the filter (The direction arrows on the top filter moulding should point AWAY FROM this fitting), this should lock into position. • Connect the remaining (longest) braided hose from the tap itself onto the stub pipe.
• P ush the open end of the supplied blue hose into water inlet of the filter (The direction arrows on the top filter moulding should point TOWARD this fitting), this should lock into position. • Screw the ⅜”BSP fitting end of the blue hose onto the cold water inlet of the reservoir/heater unit (this is the connection with the blue collar). • Ensure all connections are securely tightened, that hoses are not stretched or kinked and that all hoses are safely supported, before turning on the water supply.
Technical Specification Voltage: Rated power: Min pressure: Max pressure: Water tank capacity: 220-240Vac 50Hz 1500W 1Bar 5Bar * 2.4L * Note: the 3 in 1 instant hot water tap may safely be run from a higher pressure cold water supply provided a suitable pressure reducing valve is fitted to the cold water supply pipe.
Electrical Information Warning! This appliance must be earthed. Green and yellow to Earth A 13 Amp Brown to Live B 13 Amp fuse Cord clamp Fig. 3 Blue to Neutral The mains lead of this appliance has been fitted with a BS 1363A 13Amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover.
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:• The wire which is coloured GREEN and YELLOW must be connected to the terminal which is marked with letter (E) or by the Earth symbol or coloured GREEN and YELLOW. • The wire which is coloured BLUE must be connected to the terminal which is marked with the letter (N) or coloured BLACK.
Water Filte r The water filter shou ld be replaced e very six m onths or the guara ntee may become invalidate d. Please contact the dedicated hot tap Customer Care line for Service on the details below For after-sales advice: 01530 275531 For water filters: 01283 840545 Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu Copyright © CDA 2015 www.cda.
