Specifications

10
5. The warming drawer is supplied with three metal filler strips with
self-adhesive backing. These strips should be attached to the
warming drawer to seal any gaps between the appliance and the
housing. Remove the protective foil from each strip and position
it as shown in g. 2 so it is ush with the rear and side walls of the
housing, then attach to the warming drawer. If there is no rear wall
to the housing, the rear trim is not required.
The casing of this appliance will get hot. Ensure that any cables that
may come into contact with the appliance once installed are suitable
for use at 85°C.
Fig. 4
20-24
T
T
573
20-24
594
598
595
598
595
715-720
560-568
560-568
863-868
594
548
548
276
23
23
289
128
545
545
573
141
6
6