Manual

ManualsBrandsCDN ManualsThermometersTA20 - Audio/Visual Refrigerator/Freezer Alarm EN

Perfect For

• Maintaining food-safe temperatures

in refrigerators or freezers

Easy To Use

• Dual progress display

• Audio/visual alert

Features

• Shatterproof

• 39"/1 m sensor cable

• ABS plastic

• Sliding mode switches: F/C; refrigerator/freezer;

alert on/off

• Temperature guide

• Velcro

tabs secure case to outside surface

• Suction cup rmly attaches sensor to inside surface

• Battery and instructions included

Note: Remove sticker from display before use.

Note: In the following instructions, names of the control

buttons are shown in CAPS. Function information that appears

on the display is shown in BOLD CAPS.

Battery Installation

Battery is installed. Replace battery when LCD

becomes dim or alert level declines.

1. Open battery door in back by sliding in direction

of arrow and lift.

2. Install 1.5V AAA battery observing polarity shown

in compartment.

3. Close battery door and push in opposite direction

of arrow to lock.

Operating Instructions

1. Place the probe sensor well inside the refrigerator

or freezer in a central location by pressing suction

cup rmly against inside surface.

2. Remove the protective papers from one side of

each of the Velcro

tab pairs and adhere complete

pairs to rectangular areas on back of case.

3. Determine where the case will be mounted to

the outside surface. Wipe the surface area clean,

remove the protective papers from opposite sides

of Velcro

tab pairs, and adhere tabs to surface by

pressing rmly. Wait 15 minutes for adhesive to set

before removing case.

4. Select Fahrenheit or Celsius using sliding mode

switch on side of case.

5. Select Refrigerator or Freezer using sliding mode

switch to the far left of the display.

6. Select audio/visual alert by sliding mode switch

to the immediate left of the display to the ON

position. ALERT appears on Refrigerator/Freezer

side of the dual display when audio/visual alert

is ON.

7. Alert sounds and LED lights ash for 5 seconds

every minute when the internal temperature rises

above the safety zone.

Care of Your Product

• Avoid exposing your thermometer to extreme

temperatures, water or severe shock.

• Avoid contact with any corrosive materials such as

perfume, alcohol or cleaning agent.

• Wipe display clean with a damp cloth.

Model: TA20

Audio/Visual

Refrigerator/Freezer Alarm

Signal sounds at 15° or 46°F/-9.5° or 8°C

Suction cup rmly attaches

sensor to inside surface

Built-in sensor

ALERT appears when

audio/visual alert is ON

Probe sensor

Double-sided Velcro

tabs

for easy outside mounting

Summary of content (2 pages)

PAGE 1
Model: TA20 Audio/Visual Refrigerator/Freezer Alarm Signal sounds at 15° or 46°F/-9.5° or 8°C Perfect For Battery Installation • Maintaining food-safe temperatures in refrigerators or freezers Battery is installed. Replace battery when LCD becomes dim or alert level declines. 1. Open battery door in back by sliding in direction of arrow and lift. 2. Install 1.5V AAA battery observing polarity shown in compartment. 3. Close battery door and push in opposite direction of arrow to lock.
PAGE 2
The information in this document has been reviewed and is believed to be accurate. However, neither the manufacturer nor its affiliates assume any responsibility for inaccuracies, errors or omissions that may be contained herein. In no event will the manufacturer or its affiliates be liable for direct, indirect, special, incidental or consequential damages arisen by using this product or resulting from any defect/omission in this document, even if advised of the possibility of such damages.