Manual

ManualsBrandsCDN ManualsRelayTM8 - Multi-Task Timer & Clock EN

Features

• Dual function

• Memory

• Counts up & down

• Clock

• Stopwatch

• Loud and long alarm

• Stop and restart

• Lock

• Counts up after zero

• Food-safe ABS plastic

• Sliding mode switch

• International time

• 3-way mounting: pocket clip/magnet/stand

• Battery and instructions included

Note: Remove sticker from display before use.

Note: In the following instructions, names of the control

buttons are shown in CAPS. Function information that appears

on the display is shown in BOLD CAPS.

Battery Installation

Replace battery when LCD becomes dim or alarm

level declines.

1. Remove battery cover on the back by sliding it

in the direction of the arrow.

2. Install one LR44 battery, positive (+) side up.

A brief alarm sounds.

3. Replace the battery cover until it clicks shut.

Operating Instructions

A. Set Clock

1. Slide switch on the right side to CLOCK to

select clock mode. AM or PM appears on the

display in 12-hour time.

2. Press and hold the CLEAR button for 2 seconds

to switch between 12-hour, AM/PM time, and

24-hour, international time.

3. Press the HR MIN and/or SEC buttons

to enter the desired time. Press and hold for

fast advance.

B. Count Down

1. Slide switch on the right side to TIMER to

select the count down mode. TIMER appears

on the display.

2. Press the HR MIN and/or SEC buttons

to enter the desired time. Press and hold for

fast advance.

Note: The timer retains any time showing on the display

when the sliding mode switch is moved to another

position.

3. Press the MEMORY button to enter the set time

into memory. MEMORY appears on the display.

a. Press the MEMORY button to recall

the set time.

b. Press the MEMORY button, then press

the CLEAR button, to clear the set time

from memory.

4. Press the START/STOP button to start

counting down.

Note: TIMER ashes on the display during count down

when in other modes.

5. Press the START/STOP button to interrupt

the count. Press START/STOP again to resume

the count.

6. The alarm sounds and TIME’S UP ashes

on the display when the count reaches

0:0000. The timer counts up the overtime

since reaching 0:0000. The maximum overtime

is 10 hours.

7. The alarm and ashing stop automatically after

60 seconds while the count up continues.

Press START/STOP to stop the alarm and the

count up, and reset to 0:0000.

8. Press CLEAR when timer is stopped to reset

to 0:0000.

Model: TM8

Multi-Task Timer & Clock

Counts 24 hours by minutes & seconds

Summary of content (2 pages)

PAGE 1
Model: TM8 Multi-Task Timer & Clock Counts 24 hours by minutes & seconds Features Operating Instructions • • • • • • • • • • • • • • A. Set Clock 1. Slide switch on the right side to CLOCK to select clock mode. AM or PM appears on the display in 12-hour time. 2. Press and hold the CLEAR button for 2 seconds to switch between 12-hour, AM/PM time, and 24-hour, international time. 3. Press the HR MIN and/or SEC buttons to enter the desired time. Press and hold for fast advance. B. Count Down 1.
PAGE 2
C. Count Up – Stopwatch 1. Slide switch on the right side to COUNT UP to select the count up mode. COUNT UP appears on the display. 2. Press the START/STOP button to start counting up. Note: COUNT UP flashes on the display during count up when in other modes. 3. Press the START/STOP button to interrupt the count. Press START/STOP again to resume the count. 4. Press CLEAR when timer is stopped to reset to 0:0000.