Installation Instructions

v4-0919

Locate a second curved Inner Panel and attach it to the previous panel using the latching pins. Be sure you have

inserted the Anchor Stake Clip, and that it faces towards the center of the ring. As you are installing the panels,

manually turn the Horse Walker Hanging panel that is attached to the arm, rotating around to each panel to make sure

there is the proper clearance. After clearance is achieved, drive Stake through hole on Anchor Stake Clip, half-way into

ground as you work your way around.

IMPORTANT:

After the third or fourth curved panel,

connect the 4' panel. Adjust for proper

clearance as with the curved panels.

Install two more curved panels, then

connect the 2' panel and again, adjust

for proper clearance.

Study the diagram on the next page for

general locations for 2' & 4' at panels.

Continue installing panels around Inner

Ring to meet the Latching pins on the

Bow Gate.

Round Pen Assembly

Read Before Beginning:

Determine location of Inner Bow Gate, and at 12' from center. R

otate the Horse Walker Tree around until there is a

hanging panel in-line with the hinge side of Bow Gate. Be sure to install an Anchor Stake Clip in the bottom of each

panel before locating and attaching panel. As you install the gate and curved panels, adjust the Round Pen panels

around until there is approx. 4"- 6" of clearance between the hanging panel and curved panel on the Inner Ring and

approx. 7"- 9" on Outer Ring, as shown on page 08, under Critical Dimensions. After the Bow Gate and rst curved panel

is in place, drive one Stake half-way into the ground, (Partially drive stakes to hold panels in place - you may have to

remove previously driven stakes for adjustments) going through the holes of the Anchor Stake Clips. Repeat as you work

your way around with curved and at panels until you work all the way around to the Bow Gate.

NOTE: Do not drive stakes completely into the ground until all panels are assembled and located to allow for adjustment if needed.

Inner Ring - First

Locate position for the inner Bow Gate. Attach the Bow Gate to a curved Inner Panel

using the connector pins. Be sure the Anchor Stake Clips and the latching pins face

toward the center of the Horse Walker as shown in DETAIL A. Drive one Anchor Stake,

through hole in the clip, half-way into ground

DETAIL A

LATCHING PINS

ANCHOR

STAKE CLIP

ANCHOR

STAKE CLIP

ANCHOR STAKE CLIP

Outside View

Inside View

Outside View