Installation Instructions

v4-0919

Outer Ring - Second

Following the procedure used for the Inner Ring, locate the Bow Gate for the Outer Ring, directly across from the

Inner Bow Gate at 20'-10" from center. Connect the at 3.5' Panel. Insert Anchor Stake Clip into bottom of panel leg.

Be sure the holes on the Anchor Stake Clip face outward, away from the center of the ring. After proper

clearance is achieved, drive a Stake through the hole on Anchor Stake Clip, half-way into ground as with the inner

ring. Connect a curved Outer Panel as with Inner Ring step 1. Place another Panel and continue around Outer Ring.

Again, manually turn the Horse Walker Hanging Panel around to each panel to make sure here is the proper clearance

around the entire outer ring.

2' PANEL

5' BOW GATE

4' PANEL

REMINDER:

Only after all panels

are assembled, and

proper clearance is

achieved, drive all

anchor stakes fully.

ATTENTION:

TO ACHIEVE

PROPER CLEARANCE

AND SPACING,

BE SURE TO INSTALL

2' & 4' FLAT PANELS

OPPOSITE OF

BOW GATE, WITH

TWO (2) or THREE (3)

CURVED PANELS

IN BETWEEN.